Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
Working through AnyConnect configuration and coming across two issues. A remote test PC cannot connect with error:
"The VPN connection was started by a remote desktop user whose remote console has been disconnected. It is presumed the VPN...
Hey all,
I am going through the process of cutting over from a pfsense firewall to an ASA. I have done some test cutovers outside of hours and have fixed a number of configuration issues however I am stuck on one.
I cannot seem to get the Site to...
Hey all,
I have been working with a cisco ASA 5506-x base license, version details below:
Cisco Adaptive Security Appliance Software Version 9.8(2)38Firepower Extensible Operating System Version 2.2(2.90)Device Manager Version 7.9(2)152
I have ...
Hey Grant, Solution for me was to just upgrade ASDM and FirePower versions to the latest. We have 3 ASAs and I had issues with two of these until I upgraded. Just go through this process first and if it is still failing contact Cisco TAC. Thank you,S...
Hi Bishrom,
Did you end up getting a resolution on this?
We have upgraded from pfsense to an ASA and we used to have rate limiting that would restrict each host to only being able to get 7mb/7mb, but with the ASA I can only achieve doing an overa...
Hi JP,
Thank you for your help. So config looks like:
access-list <name> standard permit <InternalNetwork>group-policy <AnyConnectGPName> attributessplit-tunnel-policy tunnelspecifiedsplit-tunnel-network-list value <ACLName>
Thank you for point...
Hi JP,
Thank you for your help. So config looks like:
access-list <name> standard permit <InternalNetwork>group-policy <AnyConnectGPName> attributessplit-tunnel-policy tunnelspecifiedsplit-tunnel-network-list value <ACLName>
Thank you for point...
Hi JP,
Yea this seems to be the issue. I tested a connection this morning from a PC that I was not remoting to. This showed that AnyConnect works but is not sending traffic out the local WAN as I expected.
I will go through the process of setting...
