About methos365

methos365 · 05-31-2017

Hello to all, I have implemented a cluster with only one member and now i need to remove this device from the cluster in order to back up the config. Does anyone know if this action will alter in any way the configuration of the actual device or in...

methos365 · 03-02-2012

Hello to All,i am trying to implement a 4-wire shdsl line (2 shdsl lines - bounded) to a cisco 888 router with the below configuration but the line is not getting synchronized.controller DSL 0 mode atm line-term cpe line-mode 4-wire enhanced dsl-mode...

methos365 · 05-31-2017

Thank you Libin, That's what i am thinking too. I will try it and come back Rgrds,

methos365 · 03-02-2012

hello Reyad,i am not an expert.. but one idea could be to use the ip verify availability with ip sla tracks and with the appropriate set commands in the route-map change the AD of the interface. i am not sure if this is helpful at all, i haven't test...

methos365 · 03-02-2012

Hello Macro, thank you for your reply,2 different shdsl lines are terminated to my building and using a 4-wire cable these lines are bonded to one. Appropriate configuration is applied by the ISP (as i was told) at the DSLAM for this implementation. ...

Member Since	‎03-02-2012 03:44 AM
Date Last Visited	‎09-18-2019 03:40 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

ClusterConfig -> RemoveDevice - Does this infect the configuration of the actual device?

888 router and bounded 2 SHDSL lines conf issue

Thank you Libin,

WAN Problem

888 router and bounded 2 SHDSL lines conf issue