Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have two ASA5508X in our network. The Management Network for both ASAs is the same. The base problem is that i can ping from Clish-cli to internet hosts successfully on „ASA1“ but on „ASA2“ it is not possible. Please see the configuration. ******...
Two Questions:
In previous ASA Version ( v8 ) there was a "Dead Connection Detection" ( DCD) - Function to Keep inactive but already existent Connections open.
Is DCD behavior also supportet in FTD ?
Background: Using a "foreign " Firewall Connec...
I'am planning to migrate my ASA5506 from ASA/FirePower Module Configuration to Threat Defense Config.
1. I created a Smart Account and a Virtual Account in Smart Software Licensing.
2. In PLR / "PAKs and Tokens" i assigned the already fulfilled Co...
There are differences in supported firepower functionality for series 2 and 3 devices. Is there a clear view of what devices are series 2 and what devices are series 3 ?
I try to configure 2 ssid's for 1131 autonomous AP. One SSID with open authentication and WEP encryption and the other SSID using WPA. The "WEP-SSID" is in guest-mode. So i can see the "WEP-SSID" in the list of available W-Lans on a notebook but WPA ...
Hello Rob,thank you for your answer. On ASA2 I changed the gateway address from 192.168.100.253 -to-> 192.168.100.254 but without success.( >configure network ipv4 manual 192.168.100.14 255.255.255.0 192.168.100.254 )( Have set back to ...253 .) The...
Hi Francesco,
thank you for your answer.
I did not ever deal with flexconfig before. I searched how to do that and found a hint that the Connection timeout is now configurable using Service policies from Version 3.0 . So i will update fmc and sensor ...
Thank you for working on my problem. Because i thought not to get an answer i posted the problem again under "lan,switching and routing", topic "dot1q not working between ap1131 and asa5505". There are the configs already attached. Would it be possib...
