About trent.husking

trent.husking · 09-05-2011

We have ordered the new SUP2T with the 6816 line cards. We are currently using the SUP720-3B and using the 1G SFPs on board. As part of the upgrade the two chassis will be converted to VSS. As the 1G and 2 x 10G ports share the total 20G bandwidth po...

trent.husking · 04-10-2012

Hi,The fix to this DMZ issues listed above have not worked for our new deployment. We have a dedicaed WLC2504 in a DMZ with a private IP assigned. A static NAT IP assigned and UDP-5246 and UDP-5247 are allowed.The Firmware on the controller is 7.0.22...

trent.husking · 09-06-2011

Hi Leo,This was something that I also was advised however this is not the case. the 68xx series are essentially a rebranded 67xx series card with the DFC4 upgrade. They still will only support 40G per slot.The 69xx series cards do support 80G. I beli...

trent.husking · 09-06-2011

Hi Reza,Looking into this further, the 1G ports can not be used as the 10G QoS port profile needs to be enabled for VSL to function across this link.The 'palform qos 10g-only' is needed to be enabled if any of the 10G ports are used on the SUP-2T.I w...

trent.husking · 09-05-2011

Hi Leo,Think we are going aronud in circles here. Both line cards (regardless of DFC/PFC upgrade) only support a fabric of 40G. This is the limiting factor regardless of the number of interfaces.All these line card (4 - 16 port) only support 40G of f...

trent.husking · 09-05-2011

Hi Leo and Reza,The fabric bandwidth is still 40G. The 6816 provides us with better flexibility and we can group interfaces based on their requirements. Performance mode is done in 4 port groups.Yes the 6708 can have all ports used for VSL however t...

Member Since	‎09-05-2011 03:21 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

SUP2T with 6816 and VSL

5508 WLC and Office Extend AP's

SUP2T with 6816 and VSL

SUP2T with 6816 and VSL

SUP2T with 6816 and VSL

SUP2T with 6816 and VSL