Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a cisco 3800 series router connected on the LAN side to an HP ProCurve 4000m switch. I can only get this connection to come 'up' at 10half (for speed/duplex) if I set both to auto, it negotiates to 10half. All other settings and the interfac...
I just implemented a new 2821 router to replace an older 3640 series router. I copied the config exactly, however, we are not getting the same 'speed' across our frame for applications. Is there a way to test the bandwidth between my two routers fo...
I have a backup wireless circuit attached to another device. Is there a way to automate a route change when my main frame circuit goes down? As in my router sees the interface down and re-routes traffic to another router without me manually making ...
I have an Avaya PBX with an IP address of 192.168.1.30/24. I have a reporting server with an IP address of 192.168.23.230/22. If I change the IP address of the reporting server to any other IP address on the 23.0/22 network, they can communicate. ...
Sorry did not work. I ended up using a small gbit switch between the router and the LAN switch. All issues have been resolved, however, I do not like this solution.Thanks,
