Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi..We have upgraded IDS 4215 to IPS version 5.1 at one of our clients. And now we have oput it in inline mode. Scenario is as follows::Location A is connected to location B with IPS coming after router and then Firewall and then the DMZ...When i m t...
Hi,We are having a NM-1CE1T1-PRI module on our cisco 2621 XM router. We want to configure it for video conferrencing.Can anybody please guide, what configuration has to be done for this??We are currently having two serial interfaces configured and ru...
Hi,We are facing a problem from last few days. We are having WIC-2T card having Hardware Version:1.0 and Board Revision :B0. When I connect this particular WIC-2T to LOOP modem, my serial interface shows status "up" including the line protocol status...
Can anybody please tell me how to identify Cisco IOS given the part code??I want to upgrade the IOS on my Cisco 3745 router and if i got the part number as "S374AESK9-12307T", which IOS version it corresponds to?? Is it 12.4 or 12.3??? Also, can anyb...
Hi, We are having QoS implemented on 3550 switches.We have decided to replace 3550 with 3750 switch with QoS same as on 3550. But when I entered the queueing commands of 3550 on 3750 I got errors on following lines....Errors....Router(config-if)#mls ...
I already have done the same when I put it in inline mode...i was trying for icmp request and reply signatures...but it didn't work when i tested with a ping...In addition default signatures are also not getting fired..in fact nothing is shown in IPS...
Hi,I am going to use a system inside with private ip address and that will b NATTed to a public IP so if anybody tries to access this public ip, he will come in to this private ip and wud be able to do video conferencing..This is E1 PRI line. I want ...
Hi,That's right!!!But the same worked when i entered the command "invert txclock" on the serial interface having V.35 modem in LOOP make connected. At this time, the other end was having G.703 modem RAD make.But would it happen when both the ends are...
Hi,Thanks for the reply..You told this might be due to ghosting software packages on the network with lots of 7905 IP Phones...But we are using 7960 and 7940 Ip Phones..And sometimes, we don't face problems on the locations where software are install...
