Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Whenever I enable my crypto map on both sides of a serial interface, I get the following error:"CRYPTO-6-IKMP_MODE_FAILURE: Processing of Quick mode failed with peer at <IP Address>"This started happening all of a sudden with no changes to anything o...
When trying to set the clock on routers which are telnetted into, and then using the "clock set ..." command, it does not permanently set the clock. Instead, it displays the clock back to its default year of 1993 and there is a period (.) in front o...
I have tried to "write memory" a config and also attempted to save it to the startup-config but everytime I power it off and back on again, it does not save the prior config. Anyone know what the problem could be?
It is possible that an old config may have been loaded after the power outage. I do have control of both routers. I compared that config with the config that should be there and I did see one thing wrong at the router in question...it had a line in...
