Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I wonder if someone could help me as I'm pretty stuckI am trying to establish the following VPN setup?Mobile Remote User > Internet > Cisco VPN > Server (some service)Using SDM I selected the "Easy VPN Server" deployment.I am able to connect re...
Hi,Cisco 837I have enabled the basic firewall rules via SDM, is it possible to open port 54321 for torrents to a workstation IP 10.10.10.2. I have tried to add a rule, but it still shows stealth at the shields up test @grc.com.Btw; when the firew...
Hi Gilbert,Thank you for your help so far without it I would have been stuck at square one.To get familiar with VPN I attempted a second setup same as above but with a Cisco 837,I can ping 192.168.1.10 fine however cannot access it for file-sharing w...
Hi Gilbert,Thanks for your help so far1) With regards to split-tunnelling?Do I need to enable anything in SDM or the Cisco Dialler?I assume access-list 180 per ip 192.168.1.0 0.0.0.255 192.168.2.0 0.0.0.255 refers to 192.168.1.0 as the VPN side IP no...
Hi,Thanks for your help so far.You were right; I had to allocate a different IP Pool to VPN clients, so I went for192.168.2.1 to 192.168.2.10VPN Works fine, can ping internal IP's - 192.168.1.20 etcQuestions:-1) How can I access (as a remote user) th...
Hello Gilbert,>a. What is the default gateway on the server?192.168.1.1>b. Does the server have more than one NIC?Just one NIC>d. You can run debug on the router to see if we even get the packet back and respond to the client.How do I go about doing ...
Hi,I had to reset the router to factory settings via the CWRS because I couldn't access the Internet, something which I may have done with the firewall I suppose.The following attached file is the running config accessed from SDMThanks for your help,...