Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,Could someone please tell me the difference between the two commands?ip name-server <IP address>and (in DHCP pool setup)dns-server <IP address>I don't understand whether I need both of them or which one does what. Thank you,Triet
Hi everyone,We have a IPSec tunnel to the head office. Our local address pool is 10.0.0.0/24. In the router, when I ping a remote server (ping 192.168.1.1) it doesn't work. But when I ping with the source interface (bvi1 = 10.0.0.1/24), it works: pin...
Hi everyone,I created a manual binding for my DHCP service but it never worked. It always receives the dynamic PI from its parent pool. ip dhcp pool parentPool network 10.1.1.0 255.255.255.0 default-router 10.1.1.254 dns-server 139.130.4.4 61....
Hi everyone,We have a Cisco router with SSH configured. If I am physically inside the LAN, I can SSH to it via the private IP 192.168.1.1, or alternatively via its WAN IP (provided by the DHCP of our ISP).However I can't connect remotely using that W...
Hi everyone, I connect a Draytek router to Cisco router using VDPN. I have run "debug crypto isakmp" on our Cisco router. The SA was authenticated but the connection wasn't established. The show crypto session said the connection was DOWN-NEGOTIATING...
I found the cause of the problem. In the config, there was an: ip dhcp excluded-address 10.1.1.150 10.1.1.255. And the address I tried to set is 10.1.1.250.I always thought that those reserved IPs are for manual binding. Actually the manual binding i...
How do you define a Microsoft client? This is a ShoreGear switch (ShoreTel VoIP switch), I guess it is not Microsoft.However I tried this option, doesn't work either. Could you please advise another option?Thank youTriet
