Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know if the console speed of a Catalyst 3750 can be changed? The switch does not have a valid IOS image installed and the only prompt accessible is the Switch: recovery console prompt. Before using the xmodem I am hoping there is a way to...
The difference is that your internal hosts are still protected by the firewall's adaptive security algorithm. Traffic from outside to inside is allowed only if there is a matching xlate entry. As far as I know packets will not flow without you using ...
I can go through the steps individually but I think it is more appropriate if you read it in detail from the relevant portion of the configuration guide:http://www.cisco.com/en/US/products/hw/switches/ps646/products_configuration_guide_chapter09186a0...
Yes it is possible. You can install one of the various wireless HWICs available (HWIC-AP-G-A, HWIC-AP-G-E, etc.). Please refer to the following link for additional information:http://www.cisco.com/en/US/products/ps5854/products_data_sheet0900aecd8016...
You need to use port redirection with static commands to achieve this. The following link should help you in this regards:http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a0080094aad.shtml#topic9
The static nat translation is required in order for a router on the less secure side of the PIX initiate a TCP session with a router on the more secure side. Also keep in mind the suggestion by Harold on use of the norandomseq parameter with the stat...
