About okishare10

okishare10 · 10-11-2005

I want to know the correct behavior of loadbalancing using etherchannel.I used Cat3750metro and Cat3550 to see the behavior of loadbalancing using etherchannel.What I did is, connected 4 ports foretherchannel and configured "port-channel load-balance...

okishare10 · 09-08-2005

Is there any command to see dfc memory on SUP32?

okishare10 · 04-21-2005

I'm making a network using ACS in my lab and authentication fails when I telnet from a user(H1) to a router(c3845). Please look at below.What I did is, configured VPN between c3845 and c3640.I confirmed that VPN is working.Setup H1 as an user and c38...

okishare10 · 10-12-2005

Thanks for posting.From your post I found the same page.Is this the one you picked from?http://www.cisco.com/warp/public/473/4.htmlAfter reading Catalyst 3750/3560 and Catalyst 2950/2955/3550, I tried again.For Catalyst 3750/3560, I used "test etherc...

okishare10 · 09-08-2005

Will I couldn't find whether SUP32 supported DFC memory or not. If SUP32 doesn't support DFC memory then, never mind.Thanks for replying.

okishare10 · 04-21-2005

Thank you for replying my question Rick.>As for the original question: does the TACACXS server see the authentication request? I used debug tacacs authentication, packet, event and aaa authentication commmand to see whether the server was seeing the ...

Member Since	‎04-21-2005 12:02 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

Cat3750metro and Cat3550 etherchannel loadbalancing

Is there any command to see dfc memory on SUP32?

authentication failure using ACS

Re: Cat3750metro and Cat3550 etherchannel loadbalancing

Re: Is there any command to see dfc memory on SUP32?

Re: authentication failure using ACS