Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloWe currently are working on installing a 6500 Switch into our network but have come across a strange problem that I've never seen but undoubtedly someone here can probably assist me. After I install my config for the switch (pretty basic config ...
Hello,We currently are attempting to replace an older 5509 with a 6500 series switch (all version information will be below) but I am coming across a problem that I'd appreciate the community's help on please.I'll start with posting the configuration...
Hi,Our office is currently attempting to replace an older 5509 switch with a 6500 series switch. Both systems run CAT-OS which is, unfortunately, not something I'm very familiar. However, I've tried to press on and figure out this issue but so far h...
Okay, this is where I look down at my feet and shift uncomfortably. The image for the device is on one of those PCMCIA type cards. So, what I had to do was go into config mode and add the command: boot flash I then did a "wri mem"I then did a reload...
Below is the results of the verify boot flash and show bootflash for your reviewshow bootflash-#- ED ----type---- --crc--- -seek-- nlen -length- ---------date/time--------- name1 .. image 63459B18 19E4040 42 26623936 Jun 10 2009 15:33:38 +...
What's pecuilar is that our reseller took the config I am using and tried to load it onto another 6500 switch that also worked fine and boots fine. After the config is loaded he gets the same issue with the switch in his lab only booting to ROMMON. ...
This problem has been resolved. The solution was, as I thought, pretty simple. When testing your VLANs and connections, you have to be sure to have a device plugged into one of the ports on the switch. I don't know why this is but I'm guessing it h...
