Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we have Avaya IP phones model 4610. They are connected to Cisco 6513 switches. We have following configs on each 6513 switch to support Avaya IP phones. interface FastEthernet1/23 switchport switchport access vlan 60 switchport mode access switchport...
I have a 6513 as server in VTP domain, I want to disallow few vlans on the trunk ports to different switches. I am unable to do so I am running the command clear trunk 8/2 51Removing Vlan(s) 51 from allowed list.Port 8/3 allowed vlans modified to 1...
we have a very simple setupL3 switch --> Pix firewall --> internet router (cisco 2801)---> ISP We just have a default static route in L3 switch to point to pix so that all internet traffic gets routed to pix. Now we have a bunch of users using variou...
Problem context & Scenario description - We have recently implemented MPLS IP VPN with AT&T. We have 3 main offices and 10 other branch offices world wide and they all are connecting to AT&T MPLS VPN either via frame-relay or ATM ePVC. AT&T routes va...
Problem context & Scenario description - We have recently implemented MPLS IP VPN with AT&T. We have 3 main offices and 10 other branch offices world wide and they all are connecting to AT&T MPLS VPN either via frame-relay or ATM ePVC. AT&T routes va...
Thanks Mahmood I think you are right, my actual requirement is that I am having some 2950T SI switches at my access layer, I dont want certain unwanted vlans to be visible on VTP domain at those switches because I am running out of supported vlan cou...
thanks for the info, it helps, we are planning to span approx 40 vlans with 450 users at new site. Is your setup is similar to what I mentioned and if you can provide some more details around actual implementation it would be great.
Unfortunately you cannot get away by terminating at FastE, I know ISP provides RJ45 but that must be getting terminated on VWIC on 2811. RJ45 do not understand ATM format hence you would need a vwic at a minimum in order to turn up the ckt.
Lets say you have AIM card in slot 1 and VWIC card installed in WIC2 slot network-clock-participate wic 2network-clock-participate aim 1 network-clock-select 1 E1 0/2/0controller E1 0/2/0 mode atm aim 1interface ATM0/IMA3 no ip address no atm ilmi-ke...
thanks a lot folks for your expert views. It would be great if someone can post a sample config to accompalish the shaping matching to either a percent of bandwidth or a fixed kbps.
