Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently setup a Multilink bundle with 3 T's between 2 3640 routers. The link is nice and fast, and I am not getting any complaints from the user population. However, I have been wathing the bundle and I noticed that the lost fragments and reord...
Hello allI had an issue yesterday where a remote location's link went down. We thought the router was configured for both local login and TACACS+ authentication. However, the TACACS+/RADIUS server is located at the other end of the line that was d...
Hello All. I have two sites, each with a 3640 running version 12.1. I have three T1's between the two sites. I want to load balance the three T's. I was looking at Multilink PPP, but our lines are bouncing when using PPP for encapsulation. We...
Hi RickI wanted to let anyone who reads this thread know that we solved the PPP encapsulation issue. As it turns out, the problem had to do with our ACS server. AAA statments were put into the routers that caused the routers to try and authenticat...
RickWe are using the protocol OSPF for load balancing right now. We want a better solution. We haven't done anything with Multilink yet because we cannot get the T's to come up with PPP encapsulation. When we configure the lines for PPP on each ...
Thanks Rick. I was wondering if you have an answer as to why my T's won't come up using PPP. My ISP says they have nothing to do with my encapsulation problem. However, when my lines are set to PPP, they bounce all the time and sometimes will no...
