Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This example allows users with level 10 privileges to configure an interface ip address...privilege exec level 10 configure terminalprivilege configure level 10 interfaceprivilege interface level 10 ip addressMy question is how to configure users in ...
I am trying out the Multiple Privilege Level option on a directly connected router - but I cannot get it to work.This configuration example is not possible...enable secret level xxxenable secret xxx!!!!privilege configure level 6 hostname!line con 0l...
HiI am about to charge into the CCSP and I am having trouble trying to choose the correct equipment.From what I have manged to pick up on, would the following be overkill (thinking of cost here) and if so what are the best alternatives?Cisco PIX-515-...
HiCan someone please confirm if I truly understand the concept of VLANs communicating through different Switch Blocks...VLAN A is configured on an access switch which in turn is direcltly connected to the multilayer distribution Switch1. Switch1 is d...
HiI somehow managed to mess up the flash file name and now I am trying to recover the 2600 router using the ROM monitor software procedure - I am stuck in rommon mode.Has anyone tried this ??I have attached some outputs...Thanks for helping.John
Not enough This is the problem though, striking a balance between budget and actual requirements. I saw this gear posted for EUR 1.630,00 which is clearly a lot of money! I somehow doubt it will make a big diference to my studies at CCSP level - rig...
Thanks JonI realise that Cisco recommends implemnting Local VLANs design meaning that VLANs should not extend beyond the distribution switch. Also, a VLAN host might want to access remote services on a different subnet and so L3 routing might (or mig...
Yes the only way I could get this to work was through another router. Could not find a solution with a direct connection.One point to note is the file name: c2600-j1s3-mz.123-13a.binNote the .binThanks for all the help!!
