Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello allI read in the release notes, that FWSM 3.2 supports MS DCERPC inspection.How does it work?client connects to server:135/tcpA dynamic tcp port >1024 on the server is mappedclient connects to server:>1024/tcpAs far as I understood, DCERPC insp...
Hello allI setup an active/passive failover configuration on a pair of ASA5510 used as VPN concentrators and and firewall. As they permet clientless SSL VPN, port 80 and 443 on the outside interface are open (80 just for the redirection to 443).That ...
Hello allWe recently installed some new Cisco Catalyst 3560 that have some Cisco AP 1100 connected. Unfortunately, the WLSE logs all our c3560 as "unsupported device" in the discovery logs.This page claims they are supported:http://www.cisco.com/en/U...
Hi allHas anyone ever used the WLSE frame monitor? I am able to get the packets off a scanning access point to the destination specified, but I cannot properly decode the packets.It seems the scanning AP sends all frames it hears on the dot11radio0 i...
Hi allI remarked that WebVPN used to access Windows shares doesn't work properly anymore with IE 6.0 on WinXP:How to reproduce it:- login on the WebVPN- enter a Windows share to access, like \\server\share- browse to a fileNow usually, when you click...
I ran into the exactly same problem and found out that it is probably related to this:http://www.cisco.com/en/US/ts/fn/200/fn21973.html(we didn't care back then, 11 channels were enough and TX power could be limited)All our units with affected serial...
It was indeed a certificate issue, all our "older" 1121 don't have a MIC and thus need the conversion tool to generate a SSC (self signed certificate).Thanks anyway.
I had the same problem, because I loaded the recovery image manually. But I couldn't access the access point anymore, it failed during DHCP.The solution was to reload an IOS image as described in the AP1100 manual, troubleshooting section:Step 1 The ...
Thank you very much for this post. I had exactly the same problem with FWSM 4.0.6 (tcp throughput from FWSM to 6500 limited to 300Mbit/s) and the command "sysopt np completion-unit" resolved it.Dear Mr Cisco, why isn't this command enabled by default...
HelloYes. We have upgraded to FWSM version 4.0.4 and opened a TAC case for the still not working DCERPC inspection.The outcome was that the protocol is supported, but _not entirely_!!In particular the RPC communications used by Exchange 2007 are not ...
