Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having an issue on an ASR-9902-LC, XR Version 7.7.2. No response at all when trying to walk entity sensors, it just comes back instantly empty. I have been able to get other types of information like entity-physical, just not entity-sensors. It w...
I am currently playing around with integrating DNAC (CCC) into a webhook environment. I would like to define a header for the hostname in the webhook settings (CCC).
The hostname serves as an identifier in the webhook for the unique event notificatio...
Hi Cisco Community
We have used some C3560CX as office extenders and now want to activate SGT.
Unfortunately this does not work and we do not yet understand the reasons. A new C9200CX works perfectly.
There are contradictory announcements and ma...
In a current project we would like to implement a recovery scenario 1+1+1 with a witness host.
Cisco DNA Center supports two disaster recovery setups:
1+1+1 setup: OneCisco DNA Centerappliance functions as your Main Site, a second appliance serves as...
Hi
The mgbl package must be installed, and then it works perfectly. I can also confirm this from Graphana.
install activate asr9k-mgbl-x64-2.0.0.0-r7xx.x86_64
Thanks for the input.
Problem is fixed.
Kind regards,Markus
Need confirmation of stacking (to be absolutely sure):
Is a mixed with the mentioned HW types possible?
C9300X-48HXN
C9300X-48HXN
C9300X-48HXN
C9300-24UX
The following rule applies:
Mixed stacking between Catalyst 9300X and Catalyst 9300 mode...
I have the same problem as described above. We've installed two single DNAC with an Enterprise and UI address w/o any VIP (isn't a cluster setup). Any DNAC appliance are configured as a single box and build a DR 1+1+ with Witness. The Cisco Guideli...
