Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey all,I have this lab that I am working on to improve my BGP skills. The idea is that R7 is the "Internet" and R1 & R2 are failover edge routers. R5 has a loopback adapter of 25.25.25.1 and R6 has a loopback adapter of 35.35.35.1. The idea is to ha...
Hello all,I am having an issue to which I have not really be able to find a cause or resolution. The OSPF neighbor relationship between 2 routers keeps dropping, then immediately reforming the adjacency.ROUTER1GW#May 13 13:35:51 EDT: %OSPF-5-ADJCHG: ...
Hey all,I am having an issue that I am a bit perplexed with. While I am not an expert in the firewall area, I have the task of creating some rules to lock down our lab firewall. Right now most all of our VLAN rules are "permit ip any any".Here is the...
Hello everyone,I am working on getting a site to site VPN up between 2 5505s in a lab environment. I am putting a generic config on the ASAs, enough to get Internet and access to the ASDM. From there I am running the VPN wizard for site to site. Howe...
Hi all, I am working on a 5510 ASA that I have acquired and I seem to be having an issue getting gig throughput on it. I can configure it to get on the net and get the ACLs and NAT working and all that, however, when I do a speed test on my PC, I see...
Hi Harold,So I guess due to having the default network type on the loopback, and advertising something different, BGP just does not advertise due to the different masks? Interesting, good to know.On the flip side of that, what would cause the pings f...
Thank you all for the replies. We were finally able to get it working last week but I have been unable to get back to this thread until now to give an update.We found that it was the firewall for sure somehow stripping out the multicast packets betwe...
Hi Paul,Please forgive my oversight, I didn't put it in initially because we didn't think it was contributing to the problem but I am going to add it in anyway now.. We have a transparent firewall between the core switch and the router. It does not ...
