Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have ACS 3.3, & CISCO 2620 routers.Users will dial-in to the CISCO 2620 routers through PSTN line. The routers act as AAA clients. I would like to know how to enahnce the connection between routers & end-user machines. Can I configure 3DES & DES...
Hi,I have 4 Port ISDN card installed in CISCO 3745 with IOS version 12.2 (13) T8.The ISDN lines are connected to only BRI 1/0 & BRI 1/1 ports.When I give Sh ISDN status, the status of BRI 1/3 port is as belowRouter#Sh ISDN STATUSISDN BRI1/3 interface...
Hi,Can any one guide me how to verify the status of ISDN link when it is configured as backup with dialer interface?I have CISCO 3640 routers. I had configured E1 links as primary. ISDN lines are configured as backup lines.ISDN line kicks in whenever...
Hi,My network setup is as follows1. I have three routers, One Central Hub router, connecting to two spoke routers.2. The hub router has two serail links, each connecting to spoke routers.3. The hub router has one ISDN line(2B Channels) for backup.4. ...
Hi Garnett,Thanks for the reply.I had followed the configuration example earlier. If you observe the configuration, the user needs to configure the IP address of the router manually in VPN client. It is very much difficult in my scenario.In my case, ...
Hi,I went throug the documents. The configuration on the router seems to be OK. We replaced the NM-18DM module with new one. Even this change does not seems to be working.Does Any one has experienced this kind of problem any time???Thanking You,Regar...
Hi,what should be the dialer interface status, when it is configured as backup. IT shows be standby, down.When i shutdown the serial interface to test the ISDN, the dialer interface goes to Standby/Disabled, down mode.Can any one guide me on thisRega...
