About Zouyu

Zouyu · 12-10-2006

Hi,There are two 15454E-E1-42 cards raised EQPT: Equipment Failure Alarms, and no other alarms related to any ports could be found, and it seemed no service have been affected.The problem is I could not find any way to clear EQPT:Equipment Failer ala...

Zouyu · 03-26-2006

According to the EOS/EOL notice that 15454-SFP-LC-LX/SX no longer available and will be replaced by ONS-SC-GE-LX/SX.Would anyone please tell me where to find datasheet and list price of these new product?Thanks.

Zouyu · 02-14-2006

Hi allIs it possible to assign IP address within LAN in to a remote vpn client ?with the example in this exact scenario :http://www.cisco.com/warp/public/707/25a.gifcan I set an IP local pool in router as 10.2.2.10 - 10.2.2.20the problem is any remot...

Zouyu · 06-26-2005

We have 30 ONS 15454 SDH nodes installed within metro area, and have several stm-1 equipements connected to this network.There is one DCC Tunnel for each VC-4 circuits to support 3-party NMS.All VC-4 circuits have SCNP protected when fiber cuts happe...

Zouyu · 05-27-2005

I can read optical power level on my OPM whether the port has been set to IS or OOS.Would someone please tell me if it is okay?Thanks

Zouyu · 04-05-2007

Hi,According to the troublshooting guide:MEM-LOWDefault Severity: Minor (MN), Non-Service-Affecting (NSA)SDH Logical Object: EQPTThe Free Memory of Card Almost Gone alarm occurs when data generated by software operations is close to exceeding the mem...

Zouyu · 12-11-2006

Hi,Thanks for your reply.There are two 15454E-E1-42 cards in different node, and both in Slot 1, and NE running on software v6.2.2.I have not tried to switch standby TCC2 yet, and the alarms were raised one after another.I don't think these two alarm...

Zouyu · 02-21-2006

According to the Cisco IPSec config manual, Reverse Route Injection is the ability for static routes to be automatically inserted into the routing process for those networks and hosts protected by a remote tunnel endpoint. These protected hosts and n...

Zouyu · 02-19-2006

I think we may have found out where the problem was.It was all about NAT, all that we need to do was to set different ACLs to make sure any VPN flows could bypass NAT.down below is our running-config:version 12.4service tcp-keepalives-inservice tcp-k...

Zouyu · 02-19-2006

Hi,It did not work after I removed "include-local-lan" and "netmask 255.255.255.255" commands.I've been asked to follow restricted instructions to config IP pool for VPN clients with same addressing scheme as LAN's, even when it worked when I'd tried...

Member Since	‎05-23-2005 11:17 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	12

User Statistics

User Activity

15454E-E1-42 EQPT: Equipment Failure Alarms

List price of ONS-GC-GE ??

IP pool for VPN clients ?

Does SNCP support DCC Tunnel??

Does OOS setting turns off optical power?

Re: How to delete "Protect version" of TCC sw on ONS15454

Re: 15454E-E1-42 EQPT: Equipment Failure Alarms

Re: IP pool for VPN clients ?

Re: IP pool for VPN clients ?

Re: IP pool for VPN clients ?