Hello All,
I'm evaluating to achieve CCNA Collaboration and I'm wondering what kind of lab I need in order to be able to pass the exams.
Is any virtual lab available free that I can install on my PC to simulate a physical lab?
If yes, can you addres...
Hello All,
I'm having a problem with my carrier.
My router is showing short BGP flaps every days but carrier router installed at my office is not showing any down ( this is a L2 connection and I have BGP directly with remote site ).
Logs of 1st July ...
Hello all,
I'm having a problem after configured redistributing bgp to ospf on CE router.
My customer claimed that yesterday for 10 minutes his routing cleared when CE sent new network advertisement on his LAN ( there is a FW Cisco asa and a l3 bridg...
Hello to All
on CE Router XXX I have below network
XXX#sh ip route 172.16.100.1Routing entry for 172.16.100.1/32 Known via "bgp 11111", distance 20, metric 0 Tag 13879, type external Redistributing via eigrp 100 Advertised by eigrp 100 metric 30...
Hello Suresh, Kasper,
I'm evaluating to achieve CCNA Collaboration and I'm wondering what kind of lab I need.
Is any virtual lab available free that I can install on my PC to simulate a physical lab?
If yes, can you address me? I'm studying on 210-0...
Hi,
the problem was on going also before the reboot.
Here below the command
XXXX#show run | sec router bgprouter bgp 65000 bgp log-neighbor-changes timers bgp 15 45 neighbor 57.21.26.29 remote-as 13879 neighbor 57.21.26.29 description --- PE XXXXX ...
Hello Vinit,
problem is on going for last 2 months.
Here below info you required,
thanks a lot for support
Massimo
XXXX#sh versCisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.2(4)M8, RELEASE SOFTWARE (fc1)Technical Support: htt...
Hello Vinit,
ping is working fine, no MTU size
***************************
pmpm198#ping 57.21.26.29 size 1500 df-bit repeat 100Type escape sequence to abort.Sending 100, 1500-byte ICMP Echos to 57.21.26.29, timeout is 2 seconds:Packet sent with the ...
