Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Please help me configure my three switches (2xSG200-26 and 1xCatalyst3750).The goal I'm trying to reach is to provide a communication to single port to and from the two SG200-26 switches, separated by a different VLAN other than its default value...
Hi, I want to have an VLAN connection between two different switches (2960 and sg200).In default settings, all ports communicate.But I want to isolate a single port in 2960 and sg200 to communicate.What would be the settings in each port. thanks
Hi, I installed a Cisco Network Assistant but the application does not open, instead a pop up message appears.Please see attached. Please healp, Thanks, AL-QCGH
two of my routers connected to an sg200-26 can't deliver internet connection.
i can access the routers. but i noticed the 100M led in the port of the switch is off.
what would be the problem?
Already did that with no avail. It only works if configured within a single switch. The sg200-26 has a different os than the catalyst 3750, making a difficult configuration.
Hi Brian, Their is a catalyst 3750 in between connected by fiber.All VLAN setting are in the default. Please see net config.Will have multiple VLANS passing through
