Hello folks,recently I've installed Prime Infrastructure 3.10.4 Update 02 as well as the corresponding system patch. The system still wants to install "Device-Pack-1-PI3.10-14.ubf" and "PI_3_10_4_Prime_Data_Migration_Tool_Update_05-1.0.14.ubf". Both ...
Hello all, I've Prime Infrastructure 3.5 and two thrid party switches (HP ProCurve) which are succesfully imported via SNMP in the PI unter "Inventory / Device Management / Network Device / Devices Type / Third Party Device". So far so good. In the ...
Hello all, recently I changed all Access Points from 2600 series to 2800 series. After that I removed the old APs from the inventory but the folder still exists. Same with APs from 3500 series. How can I delete those empty folders? Regards,Stephan
I tried to copy a new ios image to several 3850 switche via CLI template but it failed.
The template lokks like:
#INTERACTIVE
copy tftp://10.x.x.x/cat3k_caa-universalk9.SPA.03.06.02a.E.152-2a.E2.bin flash: <IQ>Destination filename [cat3k_caa-univer...
Thanks for reply. I can delete only files wich are not in use, e.g. the device pack. This does not solve my problem. Every time when I log into Prime Infrastructure there is a red exclamation mark on the upper right corner which shows me that there a...
Yes, I can see log messages of anc Cisco-based devices (Switches and WLC) but not of third party devices. I also see SNMP traps.In a wireshark trace I can see the packets (syslog as well as SNMP) going to the PI.
Hello Balaji,I tried you proposes - unfortuantely neither the copmmand "ip source-interface all <ip-address>" nor specifing the 514/udp port and protocol were the solution. 514/udp is default, so there ois no need to change here. There are packets on...
Hi RaghasNaveed,
I don't think so. When I remember correctly we decided to update manually with an own TFTP-server based on Linux. Meanwhile we are at PI 3.1 and is looks better (just tested for one C3850 as well as one C2960). During the next weeks...
Hi Brandon,
I've created the user "iosinstall" again as you suggested and after that the scp command was working great - unfortunately only by hand...
SLT-EGDV4-255-5#copy scp://10.x.x.x//opt/CSCOlumos/images_tmp/cat3k_caa-universalk9.SPA.03.06.02a...