Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, We are looking at the Cisco 800 series.None of our wholesalers have the ISCO877-M-K9, is it possible to buy this in Australia.Secondly, can anyone clarify the difference between CISCO877-K9 and CISCO877-SEC-K9 (what does the security bundle plus ...
Hi,We have four remote sites with PIX 501's.They are approximately two years old, but we are unaware of how long this issue has persisted.We have found all of them incredibly sensitive to movement. If you stamp on the floor near one of them, it will ...
Hi, I have a PIX 501, running 6.3(5).Our ISP has done away with bridged connections, so we're forced to setup PPPoE. Works fine when I take my modem out of bridging mode and get it to do the work. My relevant config:vpdn group pppoe_group request dia...
Hi,I have a Cisco 2950, running:IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(9)EA1, RELEASE SOFTWARE (fc1)I am trying to use ntop (network monitoring tool) on a workstation. In order to setup monitoring, I have run the following commands:m...
Hi,We have taken the devices out of their homes and tested in our office, so it's not a power outlet issue.We have swapped power supplies, but as all four have the issue, it's hard to rule out the supplies.Insultating material would only be a tempora...
I'm sure this looked like a time waster to those knowledgeable, and it turns out, it was.Still not sure what happened. Power cycled the device and it seems to come up fine.
Apologies, I left this out before:c2950#show monitor session 1Session 1---------Source Ports: RX Only: None TX Only: None Both: Fa0/19Destination Ports: Fa0/24It's still throwing me that a machine on port 7, telnet to th...
Hi, see the output below:interface FastEthernet0/16 switchport mode access no ip addressendc2950#Show run int fa 0/24Building configuration...Current configuration : 73 bytes!interface FastEthernet0/24 switchport mode access no ip addressI will see ...
But I can't even get a single port working. I have our firewall (which passes all traffic leaving our network) on port 16, and now have altered the command as follows:monitor session 1 source interface Fa0/16 bothHowever the device connected to port...
