Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone got a template to use for a Cisco 800 router that will be configured with BGP on the WAN side and 192.168.10.0/30 on the LAN side.
LAN just needs to get out to the BGP network via NAT.
Anything appreciated.
Regards,
Hi,
We have a Cisco 800 that I am struggling to get an inbound NAT rule working for. I want to forward port 80 to 192.168.1.20.
Below are sections I think are relevant.
interface Vlan1 description LAN interface ip address 192.168.1.1 255.255.255.0 i...
Hi,
I have a sg500 switch. Phones are patched into it and should be put in the Voice vlan(20). Workstations are patched into the phone and should be in the data vlan(10).
Below is config for example switchport.
interface gigabitethernet1/1/8 switchp...
Hi,
I have a Cisco ASA which is the gateway for all devices.
The ASA has two LAN interfaces, 192.168.10.1/24 and 192.168.20.1/24.
There is also another router on the network that has its own WAN connection, its on 192.168.20.254(shares second subnet...
Switch port \ Port shield cisco asa? - Meta Stack Exchange
I have one redunant interface configured on my ASA with two redundant pyhsical interfaces. See below.
interface Redundant2
member-interface GigabitEthernet0/4
member-interface Gigabit...
Yep I'm applying it to the Dialer1 interface.
As soon as I apply it inbound the connection to the site just drops. Its a remote site so I need to get someone to reboot ISR to revert.
Hi Brandon,
Thanks for response.
I get the below when adding the "ip inspect FWOUT out" command to the dialer 1 interface.
%Cannot configure inspect rule on an interface which is member of a zone . Remove the interface from the zone and retry.
