Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
VOIP rookie. We have polycom handsets.Remote site has extreme x450 switches for lan connectivity. Remote sites are connected to main site via T1 on cisco 2811 routers. If I enable Auto qos voip on routers serial interfaces (Both SIdes) and CDP on pol...
I have one remote site coming in via PtP T1 into main site, that periodically stops working. I have swapped equipment (CSU/DSU, routers, cables) I will work rock solid for 1 week or 2. Then will stop working all together. Telco support says problem i...
The remote office is connected to hq via site to site vpn. I have 1 static IP (on the remote site)that I use for the site to site. I need to publish a web server at the remote site. My question is can I use the same IP for VPN and web server publishi...
I have a pix 515 with 4 port nic installed. I have outside setup with public ip inside setup up with private ip of one of my inside subnets and eth2 on ex card setup with different private subnet on our network. I need to be able to access internet f...
Kind of what I thought as well. I just wanted to eliminate a possible config problem on my end. This T1 line has been trouble from the beginning. Telco has replaced cable pairs, so they say. Is there an internal test(s) I can perform on the routers ...
show controller t1 returned no output on 2811 router not recognized on 1721(remote)show controller serial gave the result belowIs there a way to fully test the t1 cards in the router?Thank you for your comments and timemain site 2811:Interface Seria...
Sometimes restarting router fixes it, but most of the time I just put a trouble ticket on the line and wait. Maybe 3-4 hrs later it comes back on by itself.Clock source line is set on remote side/clock source internalI am running 12.3 on both routers...
