Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Im looking for a way to identify if a device is LLDP enabled, using SNMP. There's 2 scenarios in my case. 1. LLDP is enabled, but no neighbors are available(for some reasons)#show lldp neighborsCapability codes:(R) Router, (B) Bridge, (T) Telepho...
Hi, I can understand the show mac address-table can be fetched using the mentioned dot1dTpFdbTable snmp table. But the command actually displays VLAN information too. As can be seen below in the command snapshot. But the dot1dTpFdbTable has got only ...
