Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am getting below error in new 7606 installed in our network.%DEV_SELENE-DFC2-3-SRAM_ECC: Selene 0 SRAM High Single-bit ECC error, error status: 0x400182505 I am unable to find exact reason for this error over internet.Someone, please help me get de...
Hi All, I need help in creating a EEM script in Cisco router 7606 as per below requirement: >> Monitor CPU Utilization >> I want script to start working only When CPU Utilization remains more than 85% for atleast 5 minutes>> Once event is triggered i...
The place where I am working, we have 7606 router which is connected to various LAN segments. Sub-interfaces are defined in Ethernet ports for VLAN segments. Each LAN segment is running RSTP in rings, so BPDU packets is expected on VLAN subinterfaces...
Please find below DCN network overview. All Generic Routers and 3750 switch running OSPF. All interfaces of 3750, server IP and router interfaces connected to 3750 are in same network of 192.168.1.0 /24. Server is accessing whole network via 3750.Now...
We are facing issue with Cisco 7606 Router Utilization going High 99% or, even crashing due to High ARP Input Process. Even our traffic fluctuated few times during this High CPU.R1#sh sh proc cpu sortedCPU utilization for five seconds: 100%/36%; o...
Hi Jacek,
Could you please explain this script little.
What it does and how to implement?
I am also trying to find solution to save file with time on each commit command, so files are not overwritten.
I used to archive in IOS, with $h/$h and it wo...
