Hi guys,
When I try to configure fex from Port eth1/1 to 1/48 it works perfectly, but when I try to do same thing from port eth1/49 to eth1/54 the command fex associate 101 doesn't work!
It says: ERROR: Invalid port mode - not switchport
interf...
Hi guys,
I have a Cisco ACS configured with tacacs authentication for all network devices.
The TACACS authentication is working fine for all catalyst switches (authentication and permissions). But for my nexus 9k, the permissions aren’t working!
...
Hi Guys,What configuration should I use in order to configure HA using 2x Cisco WLC 2504 ? - Do I need to have licenses for 2x Controllers ? I have only one WLC with license installed. At the moment I have the following scenario below. AIR-CT2504-K...
@anthony.sarka
The Model is 93180YC-EX
FEX Support for 93180YC-EX was added starting 70(3)I5(1) and later codes.
I upgraded the NXOS to 7.0.3.I7.2 version and the "fex associate" command is working now.
Best of luck!
@Reza Sharifi You're right!
FEX Support for 93180YC-EX was added starting 70(3)I5(1) and later codes.
I upgraded the NXOS to 7.0.3.I7.2 version and the "fex associate" command is working now.
Thank you
Hi Ben,
The port is already in switchport .
This is the config below.
interface port-channel101
switchport switchport mode fex-fabric fex associate 101
I get this error message only if I try to configure any ports from 1/49 to 1/54.
If ...
Hi Francesco,
Thank you for your reply.
I don't have this user locally configured on my nexus 9k.
Here's the N9k config:
tacacs-server key 7 "MYKEY"
ip tacacs source-interface Vlan1
tacacs-server host 10.21.18.10 key 7 "MYKEY"
aaa group serv...
