Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I'm encountering problems with a FXO / FXS configuration.I have the following config:CIPC --> CCME-1 --> FXO --> connected to FXS port -> CCME-2 --> CIPCOutgoing calls from CCME-1 to CCME-2 phones are working.Incoming calls from CCME-2 to CCME...
no I cannot talk for few seconds.E.g. if I activate AutoAttendant on CCME-1 and call the number I can hear from time to time the "welc..." then the call drops. Most of the tests I do ends without hearing anything. If I forward to Voicemail I did not ...
I have a similar debug from the other side on CCME-1.Would you suggest to configure anything on the FXO port?If I establish a call from CCME-1 to CCME-2 the debug shows me, even with a regular call disconnect, a call disconnect cause value = 16
Hi,no I don't have ip connectivity and I have to use the analog ports.I did a ccapi debug but couldn't see any differences to the normal call clearing.See attachments.thx
