About frank_nye

frank_nye · 11-04-2008

I am trying to verify what wavelength our Cisco cards operate at. The cards in question are WS-X4148-FX-MT cards that we have in our Catalyst 4006 switch. I imagine they operate at a wavelength of 1300 nm (vice 850) but I need to verify so I can det...

frank_nye · 01-28-2008

We have two WS-X6348 48-port RJ-45 power-over-ethernet (POE) cards in our 6509 switch. We do not need to use these cards for POE. Can they be used for non-POE devices without any problem? Does the card have to be configured as such? We are worrie...

frank_nye · 01-24-2008

We are getting some Cisco power supplies for our Catalyst switches (6500, 5500, 4500 & 4000) that come with cords that are keyed opposite of the other ones we're using and they won't fit in our outlets.The one power supply has these specs:100-240V 16...

frank_nye · 01-28-2008

Brandon,Thanks for the reply. I see that it does state that the switch is smart enough to know an IP phone from a NIC card and not send power if it doesn't need it.I had also found a section in the Cat 6500 Switch Software Configuration Guide entitl...

frank_nye · 01-24-2008

I forgot to mention, the power cords are only keyed differently on the end that plugs into the electrical outlet. The end of the power cord that plugs into the power supply itself is the same on all of the power cords.You'd think if it was critcal t...

Member Since	‎01-24-2008 07:17 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	5

User Statistics

User Activity

850 vs 1300nm wavelength

WS-X6348 Module use for non-POE?

Power Supply Cords - keyed differently

Re: WS-X6348 Module use for non-POE?

Re: Power Supply Cords - keyed differently