Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having a problem with NTP. My network setup looks like this:2821 Router <-> ASA 5510 <-> W2k3 DCI have the router pulling time from a NIST NTP server. I want the W2k3 DC to pull from the router. I have opened a hole in the firewall to allow the ...
I am looking to block internet access for some of our hosts during specific time periods. I would like to block it by IP since I can make sure they always get the same IP with DHCP reservations. I tried to put the rule in but it wiped out the default...
I did some searching and could not come to a conclusion on this. I would like my ASA to provide NTP to my inside AD domain. My DC [Operations Master] is not able to pull NTP from the ASA.I found some posts that people "thought" that that ASA could no...
I want to have our 5510 detect when we are getting a dictionary attack on our FTP server. Do I need the IPS module in order to this or can this be done on the base unit as well?Thank you.
Here is my output:Aug 5 14:33:42.583: NTP: rcv packet from [non-NATed DC IP] to [router's internal IP] on GigabitEthernet0/0:Aug 5 14:33:42.583: leap 0, mode 3, version 3, stratum 1, ppoll 32768Aug 5 14:33:42.583: rtdel 0000 (0.000), rtdsp A0400...
So I will have to explicitly permit other traffic out right?something like this: [just free hand and in no way meant to be actual commands]access-list 100deny 192.168.0.10 based on this_time_rulepermit any to any less secure network
