Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody,I am testing N9000v image on GNS3, but can't get BGP to work. I tried all versions: 7.0.3.I5.1, 5.2, 6.1, 6.2, 7.1, 7.2, no luck.here is the config:SW1 directly connect to SW2SW1:feature bgp!interface Ethernet1/5 no switchport ip ad...
Hello everyone, please help me.
if i console into a switch using a TACACS account, then i shutdown the uplink, the switch can not talk to TACACS server, will i still be able to perform any activity? or the switch will kick me out?
thanks
Hello,
host1 only has one single IP, no default gateway, no static route, no routing protocol, "no ip routing" is configured, why it can still access 1.1.1.1?
please help. thank you.
I have a Cisco 5520 in the LAB, and every once in a while the fans start to go very loud for about 2 minutes, it is running the latest IOS, is it normal or the fan is bad? any solution to make it silence while running? thank you so much.
thank you for the reply.i mean without getting into remote router, how do i know what IP address "neighbor x.x.x.x" remote router is using for BGP peering session?
hello.
this is the current aaa configuration for the switch i am talking about, please advise, thanks.
aaa authentication login default group TACACSaaa authentication login console group TACACSaaa authorization config-commands default group TACACS l...
