Hello all,I've started for first time configuration of my new ADSL router (Cisco 837)The issue is the router coudn't get an IP adress from DHCP server of me ISPYou can see attached :- sh ver- sh ip int br- sh run& sh dhcp server: witch show no reques...
Hello,My module is not working under cisco 2811 router. I found the interfaces in the "sh ver" but when I want to use the card (card type e1) this not works Here bellow sh ver What should I do to enablethe moduleThanks##OTA96#sh verCisco IOS Software...
Hello,I'm facing an issue of configuring eigrp on my home router cisco 837. So when I lunch "router eigrp 10" command; I get nothing, I mean no thing happen & I stand in the config exec mode "R1(config)#"My IOS is 12.2Any commentsTarik
I've found the solution, see next##ADSL_Router(config)#ip routing ADSL_Router(config)#router eiADSL_Router(config)#router eigrp 10ADSL_Router(config-router)#network 172.30.96.0##Thnaks guys
Hi Sushil,Bellow the outputsh verCisco Internetwork Operating System Software IOS (tm) C837 Software (C837-K9O3SY6-M), Version 12.2(13)ZH4, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)Synched to technology version 12.2(14.5)TTechnical Support: http://www....