Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Please how can i get a real server to communicate with another virtual IP on the same CSM.i.e. according to the below, i want real servers in server farm-1 talk to any of the servers in vserver farm-2serverfarm farm-1real 10.10.10.1real 10.10.1...
Hello guys,Please how can i get real servers in a serverfarm talk to another vserver using the routed secure mode on the CSM.Note that all real servers are in the same subnet and all vservers are also on the same subnet
Hi,Please how do i get direct access to the real servers using the mode above. I can ping the real servers but i cannot connect on other ports to them.Note that the default gateway for the servers is the alias IP vlan 1 serverip add 10.10.10.10 255.2...
Hi guys,with reference to the above, i dont know why only one ip in the 10.10.10.x range passes traffic via the tunnel while the rest does not. I have the following nat policy configurednat (inside) 1 access-list xxxglobal (outside) 1 200.200.200.1-2...
Hi,I can't get the link to the document but i have attached the document. Refer to configuration examples and thenserver to server load balancingcheers
Thanks for this.However, I got a work around by creating different vlans for the serverfarms.used the cisco documentation for "server to server loadbalancing"
Hi,I have tried this method by adding the MSFC as the gateway for the server vlan but it comes back with the error message 'Gateway 10.10.20.250 does not match subnet of VLAN 1 address'
