Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have two data centers connected with only OTV link. All the network traffic flowing (extended vlans) are passing through OTV. We need to make L3 routing for few subnets which are configured on aggregation switches on both sites. How can we achieve...
Newly installed FMC virtual is not accessible through GUI. I can ping the FMC IP however, GUI is not accessible when I'm trying to reach FMC through https. Output of below commands is attached.
Version: (Cisco_Firepower_Management_Center_VMware-6.2....
I have multiple Vlans on Cisco ASA.
All of them have same security level. I have configured same-security-traffic permit inter-interface however still users of Vlan x are not able to ping users in Vlan y.
If someone can help me out how to enable co...
In below connectivity scenario how I can provide IP addresses to my wifi clients.
I'm configuring static IP config to my AP.
Wireless Clients > Access Points > Access switch
Access switch > Distribution switch (Layer 2 trunk)
Distribution switch >...
We are implementing Cisco Prime Infrastructure 3.0 in our network. We are adding network devices in Prime Cisco and then we want to integrate with third-party NMS (Netcool). How to configure Prime Infrastructure to send traps and information receive ...
No this particular IP is not being used anywhere else in the network. I changed the eth0 IP and tried pinging the IP and in that case it was not pingable anymore.
This is to inform you all if someone wonders that what happened to above-mentioned problem.
There are four ports connecting to core switches from firewalls. I created single port-channel for all four interfaces connecting to all four interfaces two e...
