Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a set up of a switch, ASA 5545, Cisco FMC and some servers.---Workstations---->Access Switch---->Cisco ASA---->ServersThe FMC is used to manage the sfr module of the ASA.At the moments workstations on the access switch have access to the serve...
CME routers C2921 are employed as the call manager in all the branches. In a branch, I configured both CP-7841 (SIP) and SP-7965 (SCCP) on the same LAN, configured dial-peers in order to call within and outside the LAN which worked well for the SCCP ...
Hi David,I am experiencing the same issue.I cannot export any network devices when I make selections or try to export all network devices.It's Cisco ISE 2.6 patch5 just like yours.Did you get any workaround?
Hi Rhoads, Thanks for you help.I just had to dedicate a workstation to be in the management vlan in order to manage the FMC just as you advised.Thanks again.
Thanks Rhoads.If I have to place the FMC in another vlan (server vlan), how do I establish connectivity to the management vlan as the routing table for the management vlan is different?
Alright, If it is server vlan, how can it reach/ping the sfr module in the management vlan?Or the sfr doesn't need to be in management vlan?Kindly shed more light?
Rhoads,The management vlan is 172.29.0.0/24.Server vlan is 172.30.225.0/24.Is it possible to configure eth0 interface of FMC in management vlan and use it for management traffic of the sfr;configure eth1 interface of FMC in the server vlan and use it...
