Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Can I have some help with the followingI have a 7k -and when doing conf tvdc my-store-fcoe type storageI get the following -Note: Creating VDC, one moment please ...Then 15 Minutes later -Note: FCoE Enable failedERROR: VDC action failed, Cleaned u...
Hi,We have an existing network with OSPF configured between 3750's (DR and BDR) this is working fine -But the Nexus 7k which has been configured to run OSPF, won't established the adj. It is in the same network/subnet. The MTU is 1500. stuck in EXSTA...
HiWe have low quality and random call failures when calling to a MPS MCU registered with H323 -So the strategy was to convert to SIP trunks.We are failing to get CUPS working to a Tandberg MPS MCU, when we convert across to SIPCUPS -> CUCM -> VCS -> ...
Hi,So we have checkd and confirmed the licensing and qos is all good -But the storage vdc created still fails after a 10-15 min wait---------------2012 Jul 12 17:18:46 AS-7010-1 %VDC_MGR-5-VDC_STATE_CHANGE: vdc 4 state changed to create in progress20...
So we have done some testing and it seems to be the vPC in the middle of the design.So OSPF between 3750A and 3750B is ok, but the neighbours do not come up between OSPF on Nexus VSS and the 3750'sAny suggestions please
This is where the problem lies,When the MPS is registered with h323 - we can apply a subzone bandwidth limit (768k), and can (mostly) complete calls but with low quality.When the MPS is changed to be a SIP neighbour (zone and search rule) it does no...
