Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm setting up some Meraki access switches and would appreciate any advice from those experienced with them.During the setup, the switches are connected to a core switch access port and start up using DHCP. This works fine, they get an IP address and...
I am using the Meraki Terraform provider to make changes to our Dashboards. We have one in Europe and one in China. Every time I want to make a change I have to change my user environment variables API key, then reboot on Win11. Does anyone know of...
Hi all, We recently turned on LLDP on our switch network and immediately four MR56 access points went offline. Turning off LLDP again and shutting down and turning on the switchports again made no difference. The line protocol shows as completely d...
Has anyone seen this error before and know how to resolve it? I've got some 9300 switches that are offline and unable to get back online, even after a factory reset. Dashboard connectivity is there as the switches are fetching the config, but not a...
If I change the core switch port to a trunk port first, then the access switch will go offline. As the access switch carries on sending untagged frames on VLAN5. If I set the native VLAN on the trunk to VLAN 5 then yes, that would bring the switch ba...
