Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Guys,I'm a CCNA/CCNP R&S and started my CCNA Security. I was trying to deploy a parser view on one of my routers just to give someone limited access. One thing I noticed is that when I created the view and start putting in the allowed commands I ru...
Guys, I've studied and lab'd out MPLS and MPLS VPNs several times. The situation I'm presented with is a little different from most of the case studies I've seen in my MPLS books. I've attached a diagram for your viewing pleasure which will hopeful...
I have a cisco ASA 5510 that I have set up currently to access via ASDM through the Inside interface. When I VPN in using our older VPN server I can connect to it fine. I recently set up the ASA to also be a VPN server which will eventually replace ...
Guys,Thanks for reading this post. I have a Cisco ASA 5510 that was set up as a VPN server for working remote. I have disabled split tunneling so that all traffic created while VPN'd in goes through the ASA. The problem I'm having I believe would...
I have a 2811 that is my HQ router with a 10MB pipe. I was trying to configure a IPSEC tunnel to connect to my ASA that has access to our companies internal servers on the 10.33. and 172.16.31 network. I am having a problem getting phase 1 to even ...
The HQ's WAN link is actually a P2P circuit connecting to the core network in the colo. So the connetion is there. I'm setting up a GRE tunnel to do this for me for now as encryption isn't needed on a P2P so GRE should be fine. However I would rea...
I'm sorry I should be more clear in my original post. The FW on the diagram just shows the HQ. It is currently just acting as the gateway for our private data. The Tunnel originates on the 2811 and goes to a cisco ASA that isn't shown on the diagr...
Thanks for the responses. Your post was the correct response needed. I had actually found it on this site under another post just before you posted here. I appreciate all the help as this now has fixed the issue. Thanks. Lee
Mike,Thats awesome. After reading your post I realized where it was hanging up at. Thanks for the help. I have since tested your solution and it works. This has added to my knowledge base on how the ASA works and views NAT. Thanks a bunch. Lee
