Hello,Can you please help me with the following?I currently have this scenario; I have two VLANs with two network ranges (192.168.2.0 and 192.168.200.0):interface Vlan2 ip address 192.168.2.3 255.255.255.0 ip access-group Sub2 ininterface Vlan200 ip ...
Hello,I'm trying to configure SPAN on my Cisco Catalyst 3560 in order to be able to mirror traffic from one port to another.To summarize, the mirroring is not working. I'm able to test if SPAN is working by checking the traffic on the network cards a...
Dear All,I've a got a Cisco 4503 Core Switch.Would it possible to extract reports? Does it have this feature by default or I needed to enable some feature to be able to generate reports?PS - Reports like bandwidth usage by IP address, Communication s...
Dear All,I've got a Cisco 4503 Core Switch with two VLANs configured.All is going OK with access lists management between the two VLANS, but now I have a scenario where I need to block only SQL traffic between two hosts on the same VLAN.Is this suppo...
Hello,I'm trying to implement Port Security on a Cisco 4503 switch. The network consists of two VLANs and 100+ users.What I basically want to do is to allow all the already learned MAC addresses to communicate over the network and block any new intro...
Hi Peter,Thank you for your answer. So it seems that my plan will do the job, thank you. The three access list will allow communication between the three VLANs for specific hosts only.Now regarding your question about my security requirement, all wha...
Hello Glen,I installed Microsoft Network Monitor and I was able to capture packets. Also please note that when I used a dumb hub instead of the switch I was able to capture all the packets and the monitoring software was working properly. So I'm pret...
Hello HTH,Please find attached the output of the commands:show interface fa 0/36show interface fa 0/46When I disabled the network card connected to fa0/46, the output of show interface fa 0/46 didn't change.Both network cards are:D-Link DGE-530T V.B1...
Hello Kerem,Thank you for your reply.I created Vlan2 and I put the source port to that Vlan but it didn't work. I then tried putting both the source and destination ports to Vlan2 but also no luck.Please find attached the updated configuration.Any ot...
