Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a customer CPE on private AS 65520 which has EBGP session to a MPLS PE device.I want to strip/hide the private AS so it uses the public AS of my PE.On the neighbor facing the CPE i have used the remove-private-as command and as-override ho...
Hi All,I'm trying to attach an extended community to a specific subnet learned from a CPE using the below confighowever i don't see this community attachedip prefix-list TEST_BGP_IN permit 192.168.1.0/24route-map TEST_ROUTE_POLICY permit 5match ip ad...
Hi Team,Please can confirm what the below config is try to achieve?Is it doing a PAT to the outside interface then allowing 10.0.255.0 coming from the outside interface to access anything? access-list outside extended permit ip 10.0.255.0 255.255.255...
Hi All,If you peer between route reflectors clusters and have them setup as back-to-back clients does this disable the cluster-id loop prevention checks? Just i see routes being sent back to originator RR and that RR accepting them. I thought the or...
Hi All,we have 2 networkseach network runs typical MPLS/IBGP and they have their own set of route reflectors (2 on each network)We want to start exchanging routes between the networks and are hoping to achieve this by peering between the route reflec...
thanks, so you would have to apply this on the IBGP session on this PE?Setup currently;CE > PE > MPLS Network > Border device > Internet CE to PE is EBGP then PE to Border is IBGP and we need to remove the private-as off the CE.Thanks
Is there a way around this at all? what do other people do to remove the private AS? should be config be done on the CPE. All i want to do is remove the customers private AS number. Thanks
