Hi Everyone,
I have a pair of Nexus 5548up in VPC mode also doing layer 3 routing between some vlans. I have an active/standby setup for my ASA firewalls. What is the appropriate method for routing traffic from the Nexus over the the ASA. Do I n...
OK thank you. I got the following advice in another thread but I was a bit confused by it.
"As for routed interfaces, for such setup you need SVI for egress vlan on Nexus (default gateway) and BVI interface bridging ingress and egress vlans on ASA."...
Hi,
I do plan on connecting the active firewall to the primary Nexus and the standby firewall the secondary Nexus. I believe you answered my question about the SVI. I plan to create a point to point VLAN/SVI that will use hrsp. I will then put the...
I will only be using a single link from the ASA. So basically active ASA will connect to "primary nexus" and standby ASA will connect to "secondary" Nexus. Also in transparent mode I am a bit confused by the VLAN subnet setup. I am planning on doing ...
Hi,
In a Nexus 5548up VPC pair which is also doing Layer 3 routing of vlans how would you properly connect a Active/Standby setup of ASA firewalls? Do you configure a routed port on the Nexus or do you create another SVI/Vlan and assign those upli...