Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
ite to site VPN tunnel - we are getting this error. one end is cisco router , another end Junier device.
(identity) local= 182.123.37.1:0, remote= 19.15.12.32:0,
(key eng. msg.) OUTBOUND local= 182.123.37.1:500, remote= 19.15.12.32:0,:500,
(key e...
Hi All,
We already configured logging. but while show logging command or monitor . its now showing any log message.
OUTPUT: show logging
Syslog logging: enabled (0 messages dropped, 0 messages rate-limited, 0 flushes, 0 overruns, xml disabled, fil...
Hi Team,
We can able to do telnet, but not able to do ssh, we checked its not configured. We tried to configure, but didn't get any ssh command in the switch.
My device details.
cisco WS-C3560G-24TS -Version 12.2(25r)SEE4
line vty 0 4
login authentic...
Hi All,
VPN tunnel monitoring:
we are getting the following error while trapping the tunnel.
Sending incorrect cikePeerLocalAddr & cikePeeRemoteAddr along with cikeTunnelStop trap due to which same ticket is being updated instead of creating new one....
Hi Satwant,
once we configure crypto key generate rsa & Ip ssh version
then only ssh will work correct,
#transport input ? all All protocols none No protocols telnet CP/IP Telnet protocol
So we given All.
I am getting this option only...
