When I use the "Auto detec hardware" option in the 3.1 QCT tool, it finds the Unity Express & 4 port FXO but it does not detect the T1/E1 card. The router is a 2821 CME 4.0 and CUE 3.0. Is this normal or should it detect it?
Setup our 2821 ISR router using the QCT tool(CME ver 4.0 and CEU ver3.0.) I used the CUE initilization wizard but it does not let me modify the individual users to create the mailboxes. The user fiels are greyed out.When I finish the init wizard it c...
Paulo/ anyone,Here is the output from the ISDN Debug Q931. I tried to dial a 10 digit #/ As you see the error is: Cause i = 0x83E020 - Mandatory information element missing. Any suggestions? debug isdn q931 is ON.Singapore#Mar 28 12:31:3...
Paulo,Great advice. Works like a champ Calls now ring into the phones. One more question: Calls come into the system fine but when I dail 91(xxx)xxx-xxxx I am getting a busy signal. Does the config you provided handle outcalling or is that something ...
A little more info. The CUE ini wizard lets me config all the paramters. it just does not let me create mailboxes and as such no PINS etc. I can dial the vm acess number and get he recording but that it. When I launch the CUE admin tool It's not allo...
In the US. It's an AT&T T-1. ISDN PRI 23 channels. Here is what shows up in the CLI output form the QCT toolcard type t1 0card type t1 0 0!isdn switch-type primary-4ess!controller t1 0/0/0default modeline b8zsframing esfclock source linepri-group ti...
