Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to pull down the full APIC configuration via the API. Rather than making API calls for nodes, tenants, vrfs etc. separately?
I haven't been able to find a way yet. If so , what's the url for the GET request?
Also, is it possible to pos...
Is there a recommended way to decommission fabric nodes before deleting them, via the API?
Currently I am pushing this json:
{ "fabricRsDecommissionNode": { "attributes": { "tDn": "topology/pod-1/node-102", "status": "created,modified...
I'm trying to access the API for the APIC-EM we've set up in the lab but am coming up against an error that I don't understand.When I visit any API link, for instance "https://<APIC-EM IP ADDR>/api/v1/pnp-device" I get the following response:{ "respo...
I have inherited a Cisco UCS C220 M3 in the lab at work and am trying to get it working. I'm logged in to CIMC but when I launch the KVM my browser just downloads a file:viewer.jnlp(10.10.10.1@0@141x7x5x7x2x1) Following advice in other threads I hav...
ok, thanks.Do you know if the PnP capabilities might ever be siphoned off APIC-EM as a standalone product/service, as this is the only capability of the APIC that we need and it would be good to be able to run PnP separately on lower end hardware?
@aradford Hi, when you say only 20 devices are supported, does this include the PnP cababilities? Will it stop pushing configurations out after it's provisioned 20 devices?
