Hi,I have one 3550 switch and i upgraded from 12.1 to 12.2(44)SE . But "tclsh" command is not enabled on this version. As per Cisco, 12.2(25)S is enough to enable TCL interpreter. Please let me know if you guys have answers.
Hi,I want to do automation for the port security using TCL . Is it possible to implement of 4849 cisco switches? where do i find relevant material to implement automation on port security?Thankskiran
Hi,We have 6513 switch which is capable of configuring Jumbo frames. We have Juniper router connected to 6513 and using Internet 2. I am confused to set up MTU and relevant adjustments on both.I believe default MTU = Default IP MTU on cisco am i true...
HiI am trying to enable net flow on interface of 6500 series switch ,I am using Sup720 3BXL. version SXH. For some reason the command "ip route-cache flow" not supported . Can any one know the correct command ?Thanks
Here is the info :Cisco#conf tEnter configuration commands, one per line. End with CNTL/Z.cisco(config)#int gi3/1Cisco(config-if)#ip flow ingress ^% Invalid input detected at '^' marker.Cisco(config-if)#ip ?Interface IP confi...
HiThanks for the reply. I have Cisco 12.2(33) SXH.Still for some reason i couldn't able to do it. Can you help me in fixing the problem? when i tab ip on interface mode, it suppose to print "route"- and next cache..ThanksKiran
Actually in my case i have VM ware switch instead of Extreme switches. What i did was , I allowed the VLAN's on trunk and sent the traffic to VMware. Ofcourse you have to configure Port channel too.This is for the interface config:interface GigabitE...