Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,From the show interface of a catalyst 6513, there is a high number of “PAUSE output†what does it mean? What is the effect of it?What should I do for this?Will it cause occation ping drop?This is my capture.5 minute input rate 78000 bits/sec, ...
Hi,I am planning to connect a edge switch direct to our core switch.What I have currently is a “primary core†and “secondary core†etherchannel together and both are configure with lower bridge priority (24577).My question are:1. If I have to...
1. For a Catalyst 6513, In the situation that the CPU utilization shoot up with no appearance reason, how and what should I look for that cause the high cpu?2. I used the show process cpu sorted 5min | exclude [0-9.]+% +[0-9.]+% +0.00%, but from the...
Need help to run GUI for FWM.I am trying to access the FWM module through https but it respond with the following error message:“Cisco PDM 4.1 for FWSM encountered loading errors. If PDM has informed you about a problem in your setup, please fix th...
Hi Guys, any help?wonder whether it got to do with the java version?which Java version support the PDM 4.1? My current Java version is JRE version 1.6.0_03 Java HotSpot(TM) Client VM thanks
Sorry, what i mean is that port-channel 2 has no IP address not vlan 4.- Do you mean the routing is form because of adjacency is form? - Assuming that Vlan 4 and vlan 5 are not configure as passive interface, it is true that “sh ip route ospf†wi...
Edison,Thanks for your sharing, so, in layer 2 the sh cdp command will show the lower vlan's IP address. This lead to another issue on layer 3, ospf.At the same 6513-1 and 6513-2no IP address are configure for both the g1/1 and g2/1 that “running p...
