Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Been out of the CUCM field for a few years, and now looking at putting a new CUCM setup into my current workplace.I have a few questions surrounding;a) what CUCM version to choose? 8.6/9.0/9.1? I am thinking 8.6 or 9.0, but does anyone have an...
Hi,I have a requirement to do IRB alongside EoMPLS, and am looking for some guidance if it is indeed possible.The setup is as follows;CISCO3925 with all host connections on the onboard EHWIC-D-8ESG-P with 152-4.M1.VLAN 2000 ----- ETHPORT1 --- EoMPLS ...
Hi,I am looking for clarification that the ethsw module, NM-16ESW, will not allow for EoMPLS support?From what I have read on CCO it seems to suggest that the EHWIC-4/8ESG is needed to support this?Basically, I had 15.2(4)M1 on my 3925, but none of t...
Hi,We have a number of datacenters within our vCenter installation, and now we are rolling out Nexus 1000v, can anyone advise if there is a restriction on the number of VSM that can be registered to a DC within vCenter?We are aware of the 64 VEM limi...
HI,When configuring L2 VPN over MPLS, I have noticed in some text documentation, MPLS config in Cisco IOS, that when viewing the LFIB via âshow mpls forwarding-tableâ the L2VPN circuit details will show ânoneâ as the outgoing interface, wher...
Hi,Thanks for reply.I will check out CUCM 9.1 in that case, and look to use CME for remote site backup.Can you advise where I can get the UC product codes and descriptions, as I cannot see these anywhere, and need them in order to obtain quotes for ...
Hello,Yes I did look at that option, however I believe it would be far more expensice, since it involves purchasing a UCS chassis, whereas we already have our own ESXi infrastructure in place.Also we would need to get two UCS to provide hardware red...
Hi,What you should do is, have area 0 between the dists and cores, and have another area between the dists, say area 1.The use area range command on dists to summarise to core, this way, each will install its own route to null0, and if it loses its l...