Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am having the following issue. My MetroE connection bounces from time to time, due to this the router starts trying to fallback and restore the connection until it gets stock. I would like to know if there is a command that I can enter on the...
Hi, We are currently using RightFax; besides that, some offices have a local fax for SRST purposes. Since they have local PRI everything works fine. My problem is in the branches where there is only analog lines. I need to move the line as well a...
Hi, I am sorry I missed that part. I am going to assume that your outbound connections are made using VPN. If so, you would have to configure your ASAs with identical profiles for the outside users. Then, you will configure your VPN client with both...
Hi, I have done so with two offices one in Miami, the other one in Texas. Since you have ASA, I will use the routing protocol (EIGRP)to take care of this automatically. What I did was to configure the backup route feature in the ASA and redistrib...
Hi, I can't see very welll your output but I believe that at the begining of the access list you have a deny any any statement. If so, that is why you might still have issues seeing the page. FYI, when you are going to modify an access list you h...
Hi, Just do show access-list from the priviliged mode (#) and you willl be able to see all the configured access lists in your router. I hope it helps, thanks.
Hi, Since you are doing from the actual router, do what stish says, do a traceroute to see the path of the traffic. If you have your circuit with AT$T they have an online tool that allows you to run test on your circuit by yourself. It is called ...
